https://mightynozzle.com/knowledge-base/anet-a8-printer-guide 3D Models, Reviews and News about 3D printer Thu, 22 Feb 2018 06:03:27 +0000 hourly 1 https://mightynozzle.com/knowledge-base/anet-a8-printer-guide#comment-44 Thu, 22 Feb 2018 06:03:27 +0000 https://mightynozzle.com/?p=249#comment-44 I would add that the builder of an Anet A8 should wire two additional power wires to the empty slots on the heated bed connector or run the risk that the connector will melt. There are 4 power pins on the bed (2 + and 2 -). The stock connector only has 1 wire on each of these. The pins are rated at 10 amps and the bed is capable of pulling 12 or more amps, which will eventually melt the connector… which is what I am replacing at this very moment, while I put on most of the upgrades that you recommend. Thank you for the designs that you made, as well.

]]>