I only tested this design for the original Rev1.3 raspbbery pi cam. If you want to use it with another cam module, check the differences of the dimensions before you print this thing.

You need following parts for vanilla raspberry camera:

• camera_holder_bracket_for_anet_a8.stl
• camera_mount_front_by_DanielBull.stl
• camera_mount_back_more_space.stl
• camera_mount_hinge_by_DanielBull.stl

You need following parts for raspberry camera with M12 hack:

• camera_holder_bracket_for_anet_a8.stl
• camera_mount_front_m12.stl
• camera_mount_back_more_space.stl
• camera_mount_hinge_by_DanielBull.stl

You can mount the holder on each of the 2 outer holes on the back of the printer:

• top left hole for the Anet A8 Board (picture). The M3 screw should be 4mm longer
• left hole of the bottom left hole of the Anet A8 board. You need a M3x16+mm screw + M3 nut and a washer (optional)
• same on the opposite side, where the power supply is mounted.

Depends on how far away your raspberry pi is from the camera, you may need a longer ribbon cable: https://goo.gl/8y9xqR
For the M12 hack, I used the lens + lens mount + lens cover from this arduino module: https://goo.gl/hfU63k

Download

Download this 3D Model on: https://www.thingiverse.com/thing:2199829

The post Anet A8 Raspberry Pi Cam Holder appeared first on MightyNozzle.

Features:

• doesn’t need much filament (about 75g PLA).
• modular – you don’t have to throw the whole case away, if you change the board. You can just use or create another board holder. Thats 10g for a holder vs 100-200g for a whole case.
• no need to drill holes in your Anet A8 acrylic frame.
• you can use the board holder without the frame!

BOM:

• 3x M3x20 mm screw (alternative M3x8 or M3x10) for RAMPS board
• 4x M3x12mm screw (alternative M3x8 or M3x10) for Raspberry Pi 2/3
• 6x M3x8mm screw (alternative M3x10 or longer) for the case lid
• 4x M3x12mm screw, if you mount the case frame with normal nut and without washer. Use M3x16mm screw for nyloc nut w/o washer
• 2x M3x16mm screw for the board holder
• 6x M3 nut (or nyloc nut)
• optional 6x M3 washer

Electronics:

• 90° angled USB A to USB B cable, if you want use the RAMPS board together with the Raspberry Pi: https://goo.gl/raHXUa
• RAMPS 1.4 Board: https://goo.gl/YBxuOz
• Mega 2560 Board (Arduino Clone): https://goo.gl/rVB4LO
• 4-5x DRV8825 Stepper Driver: https://goo.gl/TpAO0U
• Raspberry Pi 2 or 3

Download

Download this 3D Model on: https://www.thingiverse.com/thing:2195886

The post Modular Anet A8 RAMPS 1.4 + Raspberry Pi 2/3 Case appeared first on MightyNozzle.